So i bought this aukey powerbank a week ago and recently bought a high amp cable to go along with it because the previous cable only charged at about 300mah, meaning i couldn't fully charged my phone even in 8 hours.
The new cable is a gold betron one and it works brilliantly.. i think.
The aukey is a QC 2.0 version to go with my moto x force.
Recently, i've noticed that if i plug my phone into it, after turning the power bank on, it will start charging for a few seconds and then cut off as soon as my device registers that it 'turbopower is connected'
I've noticed this is quite intermittent because i dont recall my previous cable doing this (it has frayed and is a bit useless now) and my initial tryout with the new cable seemed to be fine and i got a fast 20% charge until i unplugged it.
Now all that happens most of the time is that it cuts off, as explained above. Any ideas?
The new cable is a gold betron one and it works brilliantly.. i think.
The aukey is a QC 2.0 version to go with my moto x force.
Recently, i've noticed that if i plug my phone into it, after turning the power bank on, it will start charging for a few seconds and then cut off as soon as my device registers that it 'turbopower is connected'
I've noticed this is quite intermittent because i dont recall my previous cable doing this (it has frayed and is a bit useless now) and my initial tryout with the new cable seemed to be fine and i got a fast 20% charge until i unplugged it.
Now all that happens most of the time is that it cuts off, as explained above. Any ideas?
from xda-developers http://ift.tt/2aNVUcR
via IFTTT
No comments:
Post a Comment